Discovery 3/4 Air to Coil Spring Conversion Kit - Standard Ride Height - TF265

Terrafirma TF265 Air to Coil conversion kit for Discovery 3 & 4.

Fitting Instructions (Click Here)

The NEW Terrafirma air to coil conversion kit for the Discovery 3 & 4 eliminates the likelihood of expensive air suspension repairs and the potential of becoming stranded in the event of air suspension failure. This kit comprises front and rear pre-assembled struts, a sophisticated air suspension override module and vehicle specific wiring looms.

TF265 is designed to give the same ride height as the standard setting previously on air with good load carrying characteristics. Close attention has been paid in the development to ensure ride quality and handling are not compromised and that the override module retains all the original electronic functions such as Terrain Response, Headlight Adjustment, and Information screen functions etc.

Note - In some installations it will be necessary to purchase 2 x RNG500060 to ensure correct ride height is achieved.

After fitting the coil spring struts, the vehicle should ride slightly higher than when fitted with standard air struts. This maintains the load-carrying capacity of the vehicle. However, in certain isolated cases, the ride height will be lower at the rear compared to when fitted with air struts.

In such cases it is necessary to remove the rear struts in order to fit an additional part (spacer) to each of them and then to refit the struts. The following standard Land Rover parts are required. (RNG500060)